Refer to the exhibit.



London(config)# interface range fa0/1-2 London(config-if-range)# switchp trunk encapsulation dot1q London(config-if-range)# switchp mode trunk London(config-if-range)# channel-group 1 mode active London(config-if-range)# end London#

NewYork# show etherchannel summary Flags: D - down P - in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 U - in use f - failed to allocate aggregator u - unsuitable for bundling w - waiting to be aggregated d - default port Number of channel-groups in use: 1 Number of aggregators: 1 Group Port-channel Protocol Ports --------------------------------------------------------------------- 1 Po1(S0) PagP Fa0/1(I) Fa0/2(D) NewYork# NewYork#show etherchannel port-channel Channel-group listing: ---------------------- Group: 1 ---------- Port-channels in the group: --------------------------- Port-channel: Po1 ------------ Age of the Port-channel = 00d:00h:14m:20s Logical slot/port = 2/1 Number of ports = 0 GC = 0x0000000 HotStandBy port = null Port state = Port-channel | Protocol = PAGP Port Security = Disabled

Communication between London and New York is down. Which command set must be applied to the NewYork switch to resolve the issue?

A.	NewYork(config)#no interface po1 NewYork(config)#interface range fa0/1-2 NewYork(config-if)#channel-group 1 mode negotiate NewYork(config-if)#end NewYork#
B.	NewYork(config)#no interface po1 NewYork(config)#interface range fa0/1-2 NewYork(config-if)#channel-group 1 mode on NewYork(config-if)#end NewYork#
C.	NewYork(config)#no interface po1 NewYork(config)#interface range fa0/1-2 NewYork(config-if)#channel-group 1 mode passive NewYork(config-if)#end NewYork#
D.	NewYork(config)#no interface po1 NewYork(config)#interface range fa0/1-2 NewYork(config-if)#channel-group 1 mode auto NewYork(config-if)#end NewYork#