Customer is configuring FCoE and NPV in the Cisco Nexus 5000 Series Switches. Please go through Topology and Exhibit 1 through 4 to answer questions.

Topology:

Exhibit 1:
switch# configure terminal switch(config)# npv enable
Exhibit 2:
switch#show npv flogi-table ---------------------------------------------------------------------------------------------- SERVER EXTERNAL INTERFACE VSAN FCID PORT NAME NODE NAME INTERFACE ---------------------------------------------------------------------------------------------- vfc3/1 1 0xee0008 10:00:00:00:c9:60:e4:9a 20:00:00:00:c9:60:e4:9a fc2/1 vfc3/1 1 0xee0009 20:00:00:00:0a:00:00:01 20:00:00:00:c9:60:e4:9a fc2/2 vfc3/1 1 0xee000a 20:00:00:00:0a:00:00:02 20:00:00:00:c9:60:e4:9a fc2/3 vfc3/1 1 0xee000b 33:33:33:33:33:33:33:33 20:00:00:00:c9:60:e4:9a fc2/4
Exhibit 3:
switch#show npv status npiv is enabled External Interfaces: ==================== Interface: fc2/l, VSAN: 1, FCID: Ox1cOOOO, State: Up Interface: fc2/2, VSAN: 1, FCID: 0x040000, State: Up Interface: fc2/3, VSAN: 1, FCID: 0x260000, State: Up Interface: fc2/4, VSAN: 1, FCID: OxlaOOOO, State: Up Number of External Interfaces: 4 Server Interfaces: ================== Interface: vfc3/1, VSAN: 1, NPIV: No, State: Up Number of Server Interfaces: 1
Exhibit 4:
switch# show npv status npiv is enabled disruptive load balancing is enabled External Interfaces: ==================== Interface: fc2/1, VSAN: 2, FCID: Ox1c0000, state: up
Which statement Is true regarding configuring NPV mode?

A.	When you enable NPV, the system configuration is erased and t* switch reboots
B.	When you enable NPV. the system configuration is not erased and the does not switch reboot
C.	In Exhibit 3 NPV is enabled. but Server interface to the external switch is not bed to correct vfc 2/1.
D.	m NPV mode, the core switch relays traffic from server-side ports to the edge switch and core swtich provides N ports.