Question

Which three steps are required to configure QPPB on Cisco IOS XR routers?

A.	Apply a QPPB route policy to the BGP process using the table-policy command
B.	Apply a QPPB route policy to the BGP neighbor using the route-policy command
C.	Define a QPPB route policy to match the customer routes, then set the IP precedence or qos- group
D.	Define a QPPB route policy to match the customer IP precedence or qos-group markings, then set the BGP community
E.	Enable QPPB on an interface using the ipv4 bgp policy propagation input ip-precedence\|qos- group destination\|source command
F.	Enable QPPB on an interface using the ipv4 bgp policy propagation output ip-precedence\|qos- group destination\|source command

previous question

next question

Accepted Answer

Apply a QPPB route policy to the BGP process using the table-policy command

Accepted Answer

Define a QPPB route policy to match the customer routes, then set the IP precedence or qos- group

Accepted Answer

Enable QPPB on an interface using the ipv4 bgp policy propagation input ip-precedence|qos- group destination|source command

Accepted Answer

QoS Policy Propagation via BGP (QPPB), is a mechanism that allows propagation of quality of service (QoS) policy and classification by the sending party based on access lists, community lists and autonomous system paths in the Border Gateway Protocol (BGP), thus helping to classify based on destination instead of source address.