Sign Up
Log In
Home
discussion
Exam 642-883 Question id=3410 OSPFv2 and OSPFv3 Routing in Service Provider Environments

Enter the proper CLI commands and analysis the outputs on the Cisco routers to answer the multiple-choice questions.

From the network topology diagram, click on each of the router icon to gain access to the console of each router.

No console or enable passwords are required.

There are four multiple-choice questions with this task. Be sure to answer all four questions before selecting the Next button.

Not all the CLI commands or commands options are supported or required for this simulation.

For example, the show running-config and the ping commands are NOT supported in this simulation.

All the devices in this simulation have been pre-configured and you are not required to enter in any configurations.

Scenario:
Referring to the multiarea IPv4 and IPv6 OSPF network topology diagram shown in the exhibit, use the proper CLI commands on the CE5, PE5 and PE6 routers and interpret the supported CLI commands outputs to answer the four multiple choice questions.

Note: The CE5 router is an IOS router, the PE5 router is an IOS-XR router, and the PE6 router is an IOS-XE router.


CE5#
PE5#
PE6#
Which three statements are correct regarding the OSPF operations?

A. PE5 OSPFv2 and OSPFv3 router id is 10.5.1.1
B. The OSPF virtual-link cost is 1
C. Area 3 is a transit area
D. Area 4 is using MD5 authentication
E. Area 1 IPv4 and IPv6 networks are not reachable from PE6

Answers - CDE

#show ip protocols
#show ip route ospf
#show ip ospf interfaces
#show ip ospf neighbors
#show ip ospf database
#show ip ospf border-routers
#show ip ospf
#show ip route
#show ip protocols