Enter the proper CLI commands and analysis the outputs on the Cisco routers to answer the multiple-choice questions.
From the network topology diagram, click on each of the router icon to gain access to the console of each router.
No console or enable passwords are required.
There are four multiple-choice questions with this task. Be sure to answer all four questions before selecting the Next button.
Not all the CLI commands or commands options are supported or required for this simulation.
For example, the show running-config and the ping commands are NOT supported in this simulation.
All the devices in this simulation have been pre-configured and you are not required to enter in any configurations.
Scenario:
Referring to the multiarea IPv4 and IPv6 OSPF network topology diagram shown in the exhibit, use the proper CLI commands on the CE5, PE5 and PE6 routers and interpret the supported CLI commands outputs to answer the four multiple choice questions.
Note: The CE5 router is an IOS router, the PE5 router is an IOS-XR router, and the PE6 router is an IOS-XE router.
CE5#
PE5#
PE6#
Which statement Is correct regarding the DR election process In this OSPF implementation?
| A. |
Both the CE5 and PE6 routers are DROTHERs | |
| B. |
PE5 is the OSPFv2 DR for the GigabitEthernet link between PE5 and PE6 | |
| C. |
PE6 is the OSPFv2 and OSPFv3 DR for the GigabitEthernet link between PE5 and PE6 | |
| D. |
PE6 is the DR for the GigabitEthernet link between PE5 and PE6 because it has a higher OSPF priority |
Answer - A
# show ip ospf neighbor
# show ipv6 ospf neighbor