WARNING

Question

A network engineer is trying to modify an existing active NAT configuration on an IOS router by using the following command:
Router(config)# no ip nat pool dynamic-nat-pool 192.1.1.20 192.1.1.254 netmask 255.255.255.0
Upon entering the command on the IOS router, the following message is seen on the console:
%Dynamic Mapping in Use, Cannot remove message or the %Pool outpool in use, cannot destroy
What is the least impactful method that the engineer can use to modify the existing IP NAT configuration?

A.	Clear the IP NAT translations using the clear ip nat traffic * command, then replace the NAT configuration quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.
B.	Clear the IP NAT translations using the clear ip nat translation * command, then replace the NAT configuration quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.
C.	Clear the IP NAT translations using the reload command on the router, then replace the NAT configuration quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.
D.	Clear the IP NAT translations using the clear ip nat table * command, then replace the NAT configuration quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.

previous question

next question

WARNING

the answers are mixed, do not specify in the comment number or the letter of the answer
please write answer#A instead A, answer#B instead B...

Accepted Answer

Clear the IP NAT translations using the clear ip nat translation * command, then replace the NAT configuration quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.