| Exam 300-101 | Question id=404 | Layer 2 Technologies |
Prior to enabling PPPoE in a virtual private dialup network group, which task must be completed?
| A. |
Disable CDP on the interface | |
| B. |
Execute the vpdn enable command | |
| C. |
Execute the no switchport command | |
| D. |
Enable QoS FIFO for PPPoE support |
Enabling PPPoE in a VPDN Group
Perform this task to enable PPPoE in a virtual private dial-up network (VPDN) group.
Restrictions
This task applies only to releases prior to Cisco IOS Release 12.2(13)T.
SUMMARY STEPS
1. enable
2. configure terminal
3. vpdn enable
4. vpdn-group name
5. request-dialin
6. protocol pppoe
DETAILED STEPS
| Command or Action | Purpose | |
|---|---|---|
| Step 1 | enable Example: Router>enable | Enables priveleged EXEC mode. Enter your password if prompted |
| Step 2 | configure terminal Example: Router#configure terminal | Enables global configuration mode. |
| Step 3 | vpdn enable Example: Router(config)#vpdn enable | Enables virtual private dialup networknig. |
| Step 4 | vpdn-group name Example: Router(config)#vpdn-group group1 | Associates a VPDN group with a customer or VPDN profile. |
| Step 5 | request-dialin Example: Router(config-vpdn)#request-dialin | Creates a request-dialin VPDN subgroup. |
| Step 6 | protocol pppoe Example: Router(config-vpnd-req-in)#protocol pppoe | Enables the VPDN subgroup to establish PPPoE. |