| Exam 300-085 | Question id=3990 | Configure Cisco Unity Express Using the GUI |
Refer to the exhibit.
!
interface Integrated-Service-Enginel/0
ip unnumbered Loopback0
service-module ip address 10.1.131.2 255.255.255.0
service-module ip default-gateway 10.1.131.1
no keepalive
!
Which six of the following commands are required to configure a dial peer that will allow voice-mail messages to be left on Cisco Unity Express for Unified Communications Manager Express users? The Cisco Unity Express module uses a pilot number of 4100.
| A. |
destination-pattern 4100 | |
| B. |
no vad | |
| C. |
session target ipv4:10.1.131.2 | |
| D. |
codec transparent | |
| E. |
dial-peer voice 4100 pots | |
| F. |
codec g711ulaw | |
| G. |
session target ipv4:10.1.131.1 | |
| H. |
dial-peer voice 4100 voip | |
| I. |
dtmf-relay sip-notify | |
| J. |
dtmf-relay h245-alphanumeric |