SIMULATION.
Scenario:
PE5 is an IOS-XR router. Click on the PE5 router icon to access the PE5 routers CLI
You only have access to the PE5 router CLI
The CE5 router has been preconfigured. You only need to configure the PE5 router

Your task is to configure the PE5 router per the following requirements:
1. Configure the IPv4 and IPv6 address on the loopback0 and gi0/0/0/0 interface. Refer to the topology diagram for the IP addresses to use.
2. Configure EIGRP AS 1 for both IPv4 and IPv6 routing.
3. After successfully completing all the above configurations, you should be able to successfully ping the IPv4 and IPv6 loopback addresses of the CE5 router. Only the loopbacks of CE5 can be pinged. The physical interfaces of the CE5 router cannot be pinged in this simulation.
4. The management interface (MgmtEth0/RSP0/CPU0/0) IPv4 address has been preconfigured and there is no need to enable EIGRP on the management interface.

Topology

PE5

... %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/28, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/29, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/30, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/31, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/32, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/33, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/34, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/35, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/36, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/37, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/38, changed state to administratively down %LINK-3-UPD0WN: Interface GigabitEthernet0/0/0/39, changed state to administratively down Press RETURN to get started