Sign Up
Log In
Home
discussion
Exam 200-301 Question id=5561 IP Connectivity

What command produced the following output?
Routing Protocol is "igrp 120" Sending updates every 90 seconds, next due in 44 seconds Invalid after 270 seconds, hold down 280, flushed after 630 Outgoing update filter list for ail interfaces is not set Incoming update filter list for ail interfaces is not set Default networks flagged in outgoing updates Default networks accepted from incoming updates IGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0 IGRP maximum hopcount 100 IGRP maximum metric variance 1 Redistributing: igrp 109 Routing for Networks: 172.160.74.0 Routing Information Sources: Gateway Distance Last Update 172.160.74.18 100 0:56:41 172.160.74.19 100 6dl9 172.160.74.22 100 0:25:41 172.160.74.20 100 0:01:04 172.160.74.30 100 0:02:29 Distance: (default is 100) Routing Protocol is "bgp 18" Sending updates every 60 seconds, next due in 0 seconds Outgoing update filter list for ail interfaces is 1 Incoming update filter list fcr ail interfaces is not set Redistributing: igrp 109 IGP synchronization is disabled Automatic route summarization is enabled Neighbor(s): Address FiltIn FiltOut DistIn DistOut Weight RouteMap 192.109.211.17 1 192.109.213.89 1 198.6.255.13 1 172.161.72.18 1 172.161.72.19 172.161.84.17 1 Routing fcr Networks: 192.108.209.0 192.108.211.0 198.6.254.0 Routing Information Sources: Gateway Distance last Update 172.161.72.19 20 0:05:28 Distance: external 20 internal 200 local 200

A. show ip process
B. show ip route
C. show ip protocols
D. show ip routing process

The show ip protocols command is used to view the current state of active routing protocols. This command is issued from Privileged EXEC mode. It has the following syntax:
Router# show ip protocols
This command does not have any parameters.

The output was not produced by the command show ip process or the show ip routing process. The show ip routing process and show ip process commands are incorrect because these are not valid Cisco IOS commands.

The output was not produced by the command show ip route.