Sign Up
Log In
Home
discussion
Exam 200-301 Question id=5393 IP Connectivity

You are configuring Open Shortest Path First (OSPF) protocol for IPv6 on Router5. The router has two interfaces, which have been configured as follows:

S0/0 - 192.168.5.1/24
S0/1 - 10.0.0.6/8

You would like OSPF to route for IPv6 only on the S0/0 network. It should not route for IPv6 on the S0/1 network. The process ID you have chosen to use is 25. You do not want to apply an IPv6 address yet. Which of the following command sets would enable OSPF for IPv6 as required?

A. Router5(config)#ipv6 ospf 25 Router5(config)#network 192.168.5.0
B. Router5(config)#ipv6 ospf 25 Router5(config)#router-id 192.168.5.1
C. Router5(config)# ipv6 unicast-routing Router5(config)# ipv6 router ospf 25 Router5(config-rtr)#router-id 1.1.1.1 Router5(config-rtr)#interface S0/0 Router5(config-if)#ipv6 ospf 25 area 0
D. Router5(config)#ipv6 unicast-routing Router5(config)#ipv6 ospf 25 Router5(config-rtr)#router-id 1.1.1.1

The first line enables IPv6 routing with the ipv6 unicast-routing command. The second line enables OSPF routing for IPv6 with the ipv6 router ospf command. The third assigns a necessary router ID (which was chosen at random) with the router-id command. The last two lines enable OSPF for area 0 on the proper interface.

The following command set is incorrect because it does not enable OSPF routing for IPv6, assign a necessary router ID, or enable OSPF for area 0 on the proper interface:
Router5(config)# ipv6 ospf 25 Router5(config)# network 192.168.5.0
This command set also displays incorrect use of the network command. The network command would be used with OSPF v2.

The following command set fails to enable OSPF routing for IPv6, assign a necessary router ID, or enable OSPF for area 0 on the proper interface:
Router5(config)# ipv6 ospf 25 Router5(config)# router-id 192.168.5.1
It also assigns the router ID under global configuration mode, rather than under router ospf 25 configuration mode as required.

The following command set fails to enable OSPF for area 0 on the proper interface:

Router5(config)# ipv6 unicast-routing Router5(config)# ipv6 ospf 25 Router5(config-rtr)# router-id 1.1.1.1