MIK# show interfaces serial0/0 Serial0/0 is up, line protocol is up Hardware is cxBus Serial Description: Ciscoexam.online test 200-120 MTU 1500 bytes, BW 1544 Kbit/sec, DLY 20000 usec, reliability 255/255, txload 5/255, rxload 14/255 Encapsulation HDLC, crc 16, loopback not set Keepalive set (10 sec) Last input 00:00:00, output 00:00:00, output hang never Last clearing of "show interface" counters never Input queue: 1/4096/50/1373822 (size/max/drops/flushes); Total output drops: 2460 Queueing strategy: fifo Output queue: 0/40 (size/max) 1 minute input rate 57154 bits/sec, 83 packets/sec 1 minute output rate 20589 bits/sec, 93 packets/sec 24000230464 packets input, 20473234056925 bytes, 461 no buffer Received 430703 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 19215631669 packets output, 8656077549335 bytes, 0 underruns 4 output errors, 0 collisions, 1 interface resets 0 output buffer failures, 0 output buffers swapped out 0 carrier transitions RTS up, CTS up, DTR up, DCD up, DSR up

The show interfaces serial 0/0 command was issued on the router.
Based on the output displayed which statement is correct?

A.	The cable connected to the serial 0/0 interface of the MIK router is a DTE cable.
B.	The MIK router can ping the router interface connected to the serial 0/0 interface.
C.	The clock rate used for interface serial 0/0 of the MIK router is 1544000 bits per second.
D.	The CSU used with the serial 0/0 interface of the MIK router has lost connection to the service provider.
E.	The interface of the remote router connected to the serial 0/0 interface of the MIK router is using the default serial interface encapsulation.