To allow or prevent load balancing to network 172.18.3.0/24, which of the following commands could be used in R2?
| A. |
R2(config-if)# clock rate | |
| B. |
R2(config-if)# bandwidth | |
| C. |
R2(config-if)# ip ospf cost | |
| D. |
R2(config-if)# ip ospf priority | |
| E. |
R2(config-router)# distance ospf | |
| F. |
R2(config-router)# ip ospf cost |
By default, the cost of an interface is calculated based on the bandwidth; you can force the cost of an interface with the ip ospf cost
The cost of an interface is inversely proportional to the bandwidth of that interface. A higher bandwidth indicates a lower cost.