update:
Rate (in seconds) at which updates are sent. This is the fundamental timing parameter of the routing protocol. The default is 30 seconds.
invalid:
Interval of time (in seconds) after which a route is declared invalid. The interval should be at least three times the value of update time. The interval is measured from the last update received for the route. The route becomes invalid when there is an absence of updates during the invalid time that refresh the route. The route is marked inaccessible and advertised as unreachable. However, the route still forwards packets until the flush interval expires. The default is 180 seconds.
holddown:
Interval (in seconds) during which routing information regarding better paths is suppressed. The interval should be at least three times the value of update time. A route enters into a holddown state when an update packet is received that indicates the route is unreachable. The route is marked inaccessible and advertised as unreachable. However, the route continues to forward packets until an update is received with a better metric or until the holddown time expires. When the holddown expires, routes advertised by other sources are accepted and the route is no longer inaccessible. The default is 180 seconds.
flush:
Amount of time (in seconds) that must pass before the route is removed from the routing table. The interval is measured from the last update received for the route. The interval should be longer than the larger of the invalid and holddown values. If the interval is less than the sum of the update and holddown values, the proper holddown interval cannot elapse, which results in a new route being accepted before the holddown interval expires. The default is 240 seconds.